Creadent Group - Close Circuit Cameras & CCTV System

where we care for technology

Close Circuit Cameras

As the name implies, it is a system in which the circuit is closed and all the elements are directly connected. This is unlike broadcast television where any receiver that is correctly tuned can pick up the signal from the airwaves. Directly connected in this context includes systems linked by microwave, infrared beams, etc. This article introduces the main components that can go to make up CCTV systems of varying complexity.

Probably the most widely known use of CCTV is in security systems and such applications as retail shops, banks, government establishments, etc. The true scope for applications is almost unlimited.

THE CAMERA

The starting point for any CCTV system must be the camera. The camera creates the picture that will be transmitted to the control position. Apart from special designs CCTV cameras are not fitted with a lens. The lens must be provided separately and screwed onto the front of the camera. There is a standard screw thread for CCTV cameras, although there are different types of lens mounts.Not all lenses have focus and iris adjustment. Most have iris adjustment. Some very wide angle lenses do not have a focus ring. The 'BNC' plug is for connecting the coaxial video cable. Line powered cameras do not have the mains cable. Power is provided via the coaxial cable.

THE MONITOR

The picture created by the camera needs to be reproduced at the control position. A CCTV monitor is virtually the same as a television receiver except that it does not have the tuning circuits.

SIMPLE CCTV SYSTEMS.

The simplest system is a camera connected directly to a monitor by a coaxial cable with the power for the camera being provided from the monitor. This is known as a line powered camera. Diagram 3 shows such a system. Probably the earliest well-known version of this was the Pye Observation System that popularised the concept of CCTV, mainly in retail establishments. It was an affordable, do-it-yourself, self-contained system.

The next development was to incorporate the outputs from four cameras into the monitor. These could be set to sequence automatically through the cameras or any camera could be held selectively. Diagram 4 shows a typical arrangement of such a system. There was even a microphone built into the camera to carry sound and a speaker in the monitor.

The speaker, of course, only put out the sound of the selected camera. There were however a few disadvantages with the system, although this is not to disparage it. The microphone, being in the camera, tended to pick up sound close to it and not at the area at which it was aimed. There was a noticeable, and sometimes annoying, pause between pictures when switching. This was because the camera was powered down when not selected and it took time for the tube to heat up again.

The system was, though, cheap to buy and simple to install. It came complete in a box with camera, 16mm lens, bracket, switching monitor and 12 metres of coaxial cable with fitted plugs. An outlet socket for a video recorder was provided, although reviewing could be a little tedious when the cameras had been set to sequence.

There are now many systems of line powered cameras on the market that are more sophisticated than this basic system. Most of the drawbacks mentioned have been overcome.

Cameras had been around for a long time of course, before this development. The example is given to show the simplest, practical application. The use of some line powered cameras can impose limitations on system design. They do though, offer the advantage of ease of installation.